Red Hat Certification – RHCE – Network Services – SMB

1st post – System Management and Configuration

Objectives

Network services

Network services are an important subset of the exam objectives. RHCE candidates should be capable of meeting the following objectives for each of the network services listed below:

  • Install the packages needed to provide the service.
  • Configure SELinux to support the service.
  • Configure the service to start when the system is booted.
  • Configure the service for basic operation.
  • Configure host-based and user-based security for the service.

User should be able to do the following for all these services:

SMB:

Testing an SMB server may be quite easy from Windows, but from Linux I suppose it’s a bit trickier.

The CLI client is called ‘smbclient’

The tool to set passwords: ‘smbpasswd’

You can also get some information with commands starting with ‘net’, for example ‘net -U username session’

testparm is another tool you can use to test that the config file – smb.conf – is not missing anything structural or in syntax.

The server is called ‘samba’.

There are more packages, for example ‘samba-doc’, samba4. You can find them by typing: ‘yum install samba*’

samba-doc installs lots of files in /usr/share/doc/samba*

  • Install the packages needed to provide the service.
    • yum install samba
  • Configure SELinux to support the service
    • getsebool -a |grep smb; getsebool -a|grep samba
    • /etc/samba/smb.conf # has some information about selinux
  • Configure the service to start when the system is booted.
    • chkconfig samba on
  • Configure the service for basic operation.
    • server#: open firewall (check man smb.conf, port 445 and 139 are mentioned)
    • server#: mkdir /samba; chcon -t type_in_smb_conf /samba
    • server#: edit /etc/samba/smb.conf:
      • copy an existing share – make it browseable and allow guest to access
    • server#: service smb start
    • server#: touch /samba/fileonshare
    • client#: smbclient \\\\ip.to.smb.server\\share
      • hit enter and it will attempt to log in as anonymous (guest)
    • client#: get fileonehsare
  • Configure host-based and user-based security for the service
    • server#: check that ‘security = user’ in smb.conf.
    • server#: add” writable = yes” or “read only = no” to the share in smb.conf
    • server#: smbpasswd -a username
    • server#: mkdir /samba/upload
    • server#: chown username /samba/upload
    • server#: chmod 777 /samba/upload
    • client#: smbclient -U username \\\\ip.to.smb.server\\share
    • client#: cd upload; mkdir newfolder; cd newfolder
    • client#: put file

Extra

  • Provide network shares to specific clients.
    • things you can set on the share:
      • write list = +staff
      • invalid users =
      • valid users =
      • hosts allow = 192.168.0.0/255.255.255.0
      • hosts deny =
  • Provide network shares suitable for group collaboration.
    • groupadd staff
    • usermod -a -G staff bosse
    • chown root.staff /samba/upload
    • chmod 775 /samba/upload
    • connect with bosse – do things,
    • connect with another user – can you do things?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.